The best keyboard ever built: IBM Model M

I own an IBM Model M keyboard, that I bought used. I initially bought it because it reminded me of the old XTs I used to learn DOS in. Over time, I have realized many benefits from it:

The IBM Model M

El cheapo keyboards and their rubber hills

Regular cheap keyboards (and most expensive ones) use a dome-type switch under every key — it’s a hill-shaped rubber thingie that, when you press, activates a sensor below, and when you release, pushes the key back.

They suck.

Model Ms and their clickety-clickety switches

Almost all Model Ms, in contrast, use mechanical-type switches with springs (yes, there’s a spring under each key). This is the way they work:

The buckling spring inside a Model M key

  1. When you press a key, the spring underneath it opposes an increasing amount of resistance until it sort of “gives way” (the spring actually “breaks” halfway) — and when it does, it stops resisting, clicks loudly and sends the keypress to the computer.
  2. When you release the key, the spring recovers its original form, and the key bounces back, with another click.

Many people despise Model Ms precisely for the noise and the springs’ resistance. I’m sure these people aren’t typists or heavy keyboard users — I usually refer to them as ignorants — because those characteristics are exactly why you want a Model M.

And here’s why you want one: faster typing speed, more accuracy, and less frustration.

Model Ms are more accurate

Accuracy determines how fast you type, and how frustrated you get in front of the computer. Make many mistakes a day, you’ll hate your job. Type fast with no errors, you’ll be happy.

When a key on a Model M clicks, you can be 100% sure that the key was registered. If a key didn’t click (because you pressed it too lightly), then there’s a 0% chance the key registers. Dome-type keyboards aren’t that way — there’s no click, so you can’t be sure without watching the screen — and that makes your hands exert extra pressure just to be sure keypresses get through. Mind you, not that much extra pressure — you can’t consciously tell — but the effort builds up and wears your arm muscles.

Give it a shot, if you have a cheap keyboard. Press a key lightly — lightly enough that the key “gives way” but not strongly enough for the computer to detect. You’ll see this is not only possible, but a rather frequent event. That kind of half-ass keypress isn’t possible in a Model M. Either it clicks and it works, or it doesn’t. Ever.

The feedback is more than just click-click — you actually feel it under your finger

Plus, you not only get very clear audible feedback. As stated before, the springs actually give way when the key is activated, so you can tell beyond a shadow of doubt when you activated a key, even using headphones with music at 120dB, because you feel the spring give way, and that is an unequivocal signal that your keypress has gone through. You don’t need to double-check on your screen, ever.

And that feedback is key to computing without frustration

These characteristics of mechanical-type keyboards like the Model M not only (dramatically) reduce typing errors, but they let you determine without even glancing at your screen when you’ve made a common mistake, then quickly backspace over it. This makes a brutal difference if you’re into activities that require uninterrupted concentration or simultaneously reading and typing massive amounts of text. Let me give you just one example why:

Have you accidentally hit two keys simultaneously with one fingertip? I don’t know about you, but it happens to me occasionally — especially when I move my hand back from the mouse.

With dome-type keyboards, you need to check the screen to see if one or two letters were detected (because of the half-ass keypress problem I explained above). Checking the screen before typing again sucks; yes, I know it’s only a couple seconds — however, multiply that by hundreds of mistakes a day, and you get an idea of how frustrating it gets. And every time you do it, you lose your laser-sharp focus on what you were doing.

With a Model M, you can instantly tell and correct that type of mistake — because of the tactile/audible response combo — and then you just hit the Backspace key the appropriate number of times. Two clicks/bumps in your finger, one backspace; Four clicks/bumps, two backspaces. No need to check the screen and interrupt your flow — be it dictation, thoughts or computer programming — just backspace one or two times and continue typing.

And, boy, do they last!

As for their durability… I bought my Model M used from a bank in a used-equipment sale. That keyboard had been used for a decade since 1980 — at a bank terminal on a mainframe-based character terminal system. You know, bank teller monkeys pounding on its keys all day long, nine-to-six, nonstop, for ten years. And it still works like a charm. How’s that for durability?

Test one!

So, if you’d rather spend $80 unstressing on Friday nights and $3 on your keyboard, be my guest. But if you’re into doing your job quickly while avoiding stress in the first place, you should give one Model M a spin for a week (or, if you can’t find any, perhaps Das Keyboard is your next-best bet), then tell me if you went back to your old keyboard. You won’t regret it.

3 Responses to “The best keyboard ever built: IBM Model M”

  1. acl Says:

    Amen, Brother!

    I was able to find several Ms in the warehouse at my old job (a later 1992 model, mind you). They had been in dusty storage for many years, but once connected were still as loud, dependable and delightful to use. I brought one home and used the other for everyday tasks. The others were divided amongst the ones in the know.

    I have yet to find a better keyboard, cheaper or not.

    They don’t make’em like that no more. Now get off my lawn, you lazy kids!

  2. Frank Says:

    I don’t get the fanatics when it comes to model M. Sure, everyone have their views on good keyboards, but most other people tend to realize that different keyboards fit different people. I for instance look at the screen when I am writing, because I am not a secretary and I rarely if ever have to enter anything from a written source, so I have no reason to look elsewhere. For me a greater level of resistance would provide nothing but a decrease in my possible typing speed. An audible click twice per keypress would provide nothing but disturbing my wife when she is resting. And I must say I surely do not need feedback as to if the key has registered. If I press it, I press it all the way down… if that doesn’t make it register then I need a new keyboard. Every 2-4 years I get a new keyboard for one reason or another. Maybe over an entire lifetime I’d save a penny or two by getting a longer lasting model, but I am not THAT desperate to save money. To me personally it is not worth the downsides that keyboard has to the way I use a computer. Besides, as a person who spends the majority of my waken hours in front of a computer… A flat keyboard is lightyears ahead when it comes to comfort.

  3. anthony Says:

    I have 4 Model M’s and 2 Unicomp’s. They are simply the best keyboards going. I realize they are not for everyone, they are noisy, oversized and ugly. But there is nothing else out there that compares.

Leave a Reply